![]() Strongly reccommend replacing the thermal paste with good stuff. ![]() You might want to check out this video clip of using the X-Clamp removal tool properly to see what you are up against. For sure the X-Clamp can be removed without them, but the risk of damaging your board is very high if you're not very careful. It's been suggested to me that the X-clamp remover should be in the "required" supplies. You might want an X-Clamp removal tool to make opening the console easier. Standard Soldering supplies: A variable temperature soldering iron, some solder (I like 60/40 rosin core Kester), fiberglass scratch pen, some flux paste and a very sharp set of tweezers or an exacto knife. ![]() T8 and a T10 Torx screwdriver for all the screws in the console. Some 28 or 30 gauge AWG wire (I like this ribbon cable made of 28AWG wire that can be separated and cut to length) ( Nand-X, JR Programmer, Matrix SPI Flasher, Squirt Slave Programmer, X-Flasher 360, Super Nand Flasher, PicoFlasher, or even a homemade LPT cable!) Weekend Modders Guide to RGH3 Xbox 360 Falcon and Jasper Motherboard Consoles!
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |